2024 SUPERIOR F62033HBS

2024

24V0020

New

E00066528

VALE/SUPERIOR SKID MOUNTED 6X20 WASH PLANT EQUIPPED PER THE BELOW: SUPERIOR GUARDIAN 6203HBS TRIPLE SHAFT HORIZONTAL SCREEN - ZERO DEGREE INCLINE - RIGHT HAND DRIVE - 55 DEGREE TIMING AND ZERO PLUG WEIGHTS INSTALLED - COIL SPRINGS WITH MHSA GUARDS - ALL DECKS SIDE TENSIONED WITH 5FT CLAMP BAR CONFIGURATION - VALE SUPPLIED BASEFRAME STRUCTURE - STRUCTURAL ENGINEERED SUPPORT FOR ONE 6X20 SCREEN - WELDMENT AND BOLT TOGETHER DESIGN - INCLUDING ALL FASTENERS FOR FIELD ERECTION PLAFROM, HANDRAIL, LADDER - SCOPE INCLUDES 2’ WIDE PLATFORM ON 2 SIDES AND AT BACK OF SCREEN - LOCAL PLATFORM OVER SCREEN DRIVE MOTOR STANDARD DESIGN - CHECKER PLATE PLATFORM WITH 6” KICK PLATES - 42” HSS 1.5” HANDRAIL WITH MID-RAIL AND POSTS, REMOVABLE - SAFETY GATE, SELF-CLOSING, UP TO 30” WIDE ACCESS POINTS STAIRCASE ACCESS - APPROXIMATELY 16 RISER STAIRCASE - DIAMOND GRIP STAIR TREADS 9.5 X 30” - C6 CHANNEL - HSS 1.5 HANDRAIL WITH MID-RAIL AND POSTS SCREEN FEED PUMP BOX - ENGINEERED STRUCTURAL SUPPORT FOR ONE SLURRY BOX 6’X6’X4’ - MOUNT PUMP BOX DIRECTLY OVER SCREEN FEED BOX - 10” FLANGE TO CONNECT PIPING - PIPE, ELBOWS AND FITTINGS FROM GRADE TO PUMP BOX BY END USER - 1/2" URETHANELINERS PLUG WELD SCREEN DISCHARGE FRAME AND CHUTES - ROLLOUT FRAME - MANUAL ROLL AND PIN SYSTEM - TOP DISCHARGE CHUTE SLOPED 3/8” PLATE DESIGN 1/4” AR 400 LINER WELD IN - MIDDLE AND BOTTOM DECK CHUTES WITH ROCK SHELF 1/4” PLATE 1/2” URETHANE STEEL BACKED PLUG WELD UNDER SCREEN FLUME - 1/4” PLATE HOPPER WITH SLOPED SIDEWALLS - 1/2" URETHANE LINER PLUG WELD DISCHARGE TO SUMP: - SUMP SUPPLIED BY OTHERS - PIPING FROM SUMP TO SCREEN FEED PUMP BOX BY OTHERS WASH MANIFOLD/SPRAY BARS - FULL LENGTH 6” X 6“ MANIFOLD WITH 6” BOLT FLANGE FOR WATER HOOKUP - INDIVIDUAL GATE VALVES FOR ADJUSTABLE WATER FLOW - 4 FLUSH VALVES TO UNDER SCREEN FLUME LOCATED AT FEED AND DISCHARGE - 16 BAR WASH KIT INCLUDING BOOTS, SPRAY BARS AND BRASS NOZZLES FOR SCREEN SUPPLIED BY VALE - 6” FRESH WATER FEED PIPE, ELBOWS AND FITTINGS FROM GRADE TO MANIFOLD BY OTHERS - ELECTRICAL SWITCHGEAR AND POWER CORD NOT INCLUDED AT THIS TIME - CONCRETE FOUNDATION RECOMMENDED TO SUPPORT STRUCTURE AND VIBRATORY EQUIPMENT, WARRANTY COULD BE DENIED IF FOOTING ALLOWS MOVEMENT AND SUBSEQUENT VIBRATION AND FALIURE OF FOUNDATION. - CRANE,INSTALLATION AND ASSEMBLY ONSITE NOT INCLUDED - ELECTRICAL SG PANEL AND POWER CORDS NOT INCLUDED - OWNER’S MANUAL AND PARTS LIST - GUARDING - WE DO NOT WARRANT THAT MANUFACTURERS’ GUARDING WILL MEET ALL LOCAL CODES. IT IS THE RESPONSIBILITY OF THE END USER TO HAVE GUARDING CHECKED BY A LOCAL INSPECTOR, PRIOR TO STARTUP OF EQUIPMENT OPERATIONS, CORRECTIVE ACTIONS AND ASSOCIATED EXPENSE ARE THE RESPONSIBILITY OF THE END USER.