2005 TITAN 48 ft

2005

2K9WF1L255H035252

Used

U55H035252

2005 TITAN 48' WALKING FLOOR TRAILER Base Model 48-2-TW-WF Style Straight Overall Length 48 ft Overall Width 102” Nominal Overall Height 13’ 1 ¼” Approximately King Pin Location 36” Upper Couple Ht 40” Number of Axles PRIMARY Two (2) Axles D22-.625 Wall Dana Axle Track 77” Suspension Watson Integra 30,000 lb @ 50” Hub / Drum Assembly Duralite-10 hole Disc Wheel Size 14 x 22.5 Rims Aluminum Tires Brand Michelin Quantity 4 445/50R22.5 Axle Layout FRONT-Primary-50-Primary-29.5-REAR Oil Seals Chicago Rawhide Lubricants Oil Brakes ABS 4S2M Meritor Wabco Slack Adj. Haldex Auto Cam Enclos All Axles – c/w Dust Shields Lift Kits None Lift Controls None Frame Width 48” Rear Bumper Flush Rear bumper with rubber tipper bumpers & D ring style tow hooks Tire Carrier None Landing Gear STD. Jost Landing Gear Top Rail Tapered H.D. Top Cross Tube 1 piece 1 spring bar in middle of trailer Floor Crossmembers 12” Centers X bracing required Keith Walking Floor Kit Running Floor II – 3” Dia Cylinders Stal Model & Width 2299 (1914 CWS) 3 ½” (Center wear strip) T-Blocks Rear Slat Wear Strips None Continuous Bearing Continuous bearing full length Side Wall Wear Plates None Tarp Style None Tarp Header Front & Rear Tarp Basket None Tarp Hooks Install tarp hooks on crossmembers near the sidewall at 48” o/c, 4 hooks on rear door Axle Fender None Hyd Fitting Pressure Wing Coupler Return Wing Coupler Mud Flaps Style Titan Black Rubber Location Rear Mud Flaps – Landing Gear None Access Catwalk- Front None J-Ladder-Front J- Ladder centered with flip up step below, installed over air & electrical. Ladder-Rear Located in center of rear door Steps-Front-Out None Steps-Front-Ins None Steps-Rear Located on driver side so door swings open as far as possible Additional work completed at KTR : - Prep trailer - Pressure wash name and loose paint off trailer - Pull floor to be turned, clean out bearings - Remove hydraulic, air and electrical lines as needed from kingpin section - Cut and remove kingpin section, grind clean areas to be rewelded - Cut and remove bottom front panel, grind clean, fit new panel and weld in place - Cut and fit kingpin section into trailer, fit bi-metals to kingpin and trailer, weld all in place - Reattach hydraulic, air, and electrical to kingpin - Repair crossmembers as needed - Turn floor, add wear strips, weld up bolt holes - Reinstall slats, drill holes and bolt downbolt down - Install new bulkhead fittings and hydraulic hoses with female wingnut couplers on front of trailer - Repair replace lights as needed - Replace inner door hinge, repair winder as needed - Check ABS operation, replace cable and sensor to repair - Repair water seal track and install new seal, replace broken tailgate hinge - Repair frame rail and reinforce both sides - Repair holes on outside of trailer, patch holes inside trailer

48 ft