2022 CATERPILLAR D8T LGP

2022

8,628

AW401430

Used

D4320

CAT D8T LGP with 38" Track Shoes, Fully Maintained By CAT Dealer, Equipped w/ CAT 14’6” Semi U Blade w/ Tilt, Drawbar, Auto Reverse Cooling Fan w/ Brush Guard. Ripper Or Winch Are Available. WARRANTY INCLUDED. Caterpillar D8T LGP with WARRANTY INCLUDED featuring: • CAT C15 ACERT Engine • Engine Block Heater • Powershift Transmission • Cab (ROPS) w/ A/C • Differential Steer • Auto Reverse Cooling Fan w/ Brush Guard • 38" Track Shoes • CAT Semi U Blade w/ Tilt - 14'6" Wide • CAT Slope Indicate • Equipped w/ Drawbar • Ripper is Available - Extra • Winch is Available - Extra • Ripper Valve • Rear Window Screen • Top Carrier Rollers • LED Flood Light Arrangement • Heavy Duty Bottom Guards • Rated at 394 HP • Weight 85,000 LBS Repair / Condition Report When this D8T LGP Crawler Dozer arrived in yard, MEL had our local CAT dealer, Toromont CAT, complete the following at 8,628 Hrs: • Strip all Belly pans, covers and panels from machine for power washing • Completed CAT TA 1 Plus inspection • Update ECM flash files • Check for logged & active codes & repaired • Check for applicable service letters • Inspected Emissions system for servicing • Changed and Cut open all Oil filters & inspected for contaminates - All Clean • Inspect magnetic plugs/screens & suction screens - All Clean • Serviced engine • Changed fuel tank breather and cleaned filler screen • Changed transmission and hydraulic breathers • Changed all air filters and cab filters • Inspect oils for discoloration • Changed engine, transmission, hydraulic and final drive oils • Check oil levels Completed the following Pressure Checks to ensure within OEM spec: • Fan pressure & speed - completed fan calibrations. • Engine RPM high & low idle • Engine oil high & low idle pressures • Fuel pressure checks • Transmission and Torque convertor checks • Torque convertor stall speed • Full stall boost - Full stall speed • All Hydraulic system checks • All Steering system checks • Brake pressure checks • Performed all machine Calibrations Based on the CAT dealer inspection, CAT Tech and Marcel Tech completed the following repairs: • Replaced damaged Radiator harness with New harness • Replaced damaged Fan with New • Replaced 2 fan hoses • Replaced Master power Disconnect switch and Shutdown switch • Replaced Transmission oil filter by-pass switch • Replaced ARD head fuel supply solenoid coil • Cleaned all Battery cables • Replaced Engine thermostats • Replaced Heater hose taps • Replaced lower coolant drains • Replaced Radiator cap • Replaced Transmission cooler hose, Torque scavenge hose and both Filter hoses • Re-sealed all fittings • Re-sealed Transmission lube manifold block, fittings & sensors • Replaced flywheel lube hose • Re-sealed Torque convertor drain • Replaced front Engine Crankshaft seal • Replaced Serpentine belt and belt tensioner with New • Replaced Throttle switch • Replaced all Lift Cylinder mounting bushings • Removed & cleaned HVAC box & replaced damaged drain hoses • Replaced A/C drier • Charged A/C to spec and tested operation • Remove LH track frame • Disassemble recoil spring to inspect for cracks • Re-seal track left adjuster • Re-seal outer pivot shaft seal • Replaced left canon seal • Install new pins for hard bar • Replace both track frame fluids • Replaced both Top carrier rollers • Repaired cab seat Suspension • Replaced Def header • Line bored bottom holders on blade • Line bored both push arms • Line bored tilt link • Installed all NEW pins and bearings • Re-assembled machine • All panels, railings, grab handles are straight & in place • Detailed machine This CAT D8T LGP Tractor is Completed and Work Ready. The following are Repairs completed by CAT Dealer prior to Marcel Equipment owning the machine: At 8,600 hours, installed NEW alternator At 8,455 hours, installed NEW DEF injector At 8,344 hours, performed 1000 hour service At 7,674 hours, performed 500 hour service At 7,170 hours, performed 2000 hour service At 7,160 hours, installed NEW batteries At 7,154 hours, installed NEW a/c compressor & dryer At 6,680 hours, performed 1500 hour service At 6,011 hours, performed 1000 hour service At 5,527 hours, installed NEW DEF manifold At 5,108 hours, installed REMAN DPF filter At 4,947 hours, performed 500 hour service At 4,465 hours, performed 5000 hours service At 3,929 hours, performed 1500 hour service At 3,359 hours, performed 1000 hour service At 2,902 hours, performed 500 hour service At 2,845 hours, installed NEW throttle position sensor At 2,394 hours, performed 2000 hour service At 1,752 hours, performed 1500 hour service At 1,153 hours, performed 1000 hour service At 538 hours, performed 500 hour service

Enclosed